YSI MultiLab 4010P-1 - Manual (Page 71)

MultiLab 4010-1 Settings
ba76141e03 03/2014 71
ORP The following settings for ORP measurements are reset to the default settings
with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the
Dissolved oxygen The following settings for D.O. measurements are reset to the default settings
with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the
Conductivity The following settings for conductivity measurements are reset to the default
settings with the Reset function:
Setting Default settings
mV resolution 0.1
Man. temperature 25 °C
Setting Default settings
Calibration interval 180 d
Measured parameter D.O. concentration (mg/l)
Salinity (value) 0.0
Salinity (function) off
Resolution 0.1
DO % Saturation local off
Setting Default settings
Calibration interval 150 d
Measured parameter
ϰ
Cell constant (c) Depending on the connected mea-
suring cell:
0.475 cm
-1
(calibrated)
0.475 cm -1 (set)
0.100 cm
-1
Temperature compensation nLF
Reference temperature 25 °C
Temperature coefficient (TC) of the
linear temperature compensation 2.000 %/K
Multiplier for TDS 1.00