YSI MultiLab 4010P-1 - Manual (Page 68)

Settings MultiLab 4010-1
68 ba76141e03 03/2014
9.5 Sensor-independent settings
9.5.1 System
To open the Storage & config menu, press the
Menu item Setting Description
System / General / Language Deutsch
English
(more) Selects the menu language
System / General / Audio signal on
off Switches on/off the beep on keystroke
System / General / Illumination Auto
on
off Switches the display illumination on/off
System / General / Contrast 0 ... 50 ... 100 Changes the display contrast
System / General / Shutoff time 10 min ... 1h ... 24 h Adjusts the shutoff time
System / General / Temperature
unit °C
°F Temperature unit,
degrees Celsius or degrees Fahrenheit.
All temperature values are displayed
with the selected unit.
System / General / Stability con-
trol on
off Switches on or off the automatic stability
control during measurement (see sec-
tion 9.5.3 A
UTOMATIC S TABILITY CON -
TROL , page 69 )
System / Interface / Baud rate 1200, 2400, 4800,
9600, 19200 Baud rate of the USB Device interface
System / Interface /
Output format ASCII
CSV Output format for data transmission
For details, see section 11 T
RANSMIT -
TING DATA (USB INTERFACES ), page 79
For: Output format CSV:
 System / Interface / Decimal
separator Dot (xx.x)
Comma (xx,x) Decimal separator
 System / Interface / Output
header Output of a header
System /Clock function Date format
Datum
Time Settings of time and date.
For details, see section 4.5.5 E
XAMPLE 2
ON NAVIGATION : S ETTING THE DATE AND
TIME , page 26
System /Service information Hardware version and software version
of the meter are displayed.