YSI DIQ/S 182 XT-4-PR - Manual (Page 86)

The SETTINGS menu System 182 XT-4
5 - 2 ba76027e01 02/2012
5.2 Language
In this menu, you can set the system language.
Procedure: Selecting
the language
Note
If the selected system language is not available in a sensor, all displays
of this sensor appear in the standard language, English. To activate the
selected system language for this component, a software update of the
component is required. Contact YSI.
5.3 Sensor S01 to S04
In this menu, you can assign a name of your choice to a sensor and
adjust the sensor so it optimally meets the requirements of your
application (measured parameter, measuring range, etc.).
All settings are specific for the respective sensor type. They can only
be modified if the sensor is connected and communicates properly with
the DIQ/S 182 XT-4-PR. Otherwise, the dataset is inactive. How to deal
with inactive datasets is described below.
Note
General steps for editing sensor settings are given below. The
Sensorname menu item is always on the first position of the setting
table. Details of further sensor settings can be found in the chapter,
C
OMMISSIONING of the sensor operating manual.
1 Open the SETTINGS menu with
s
.
2 Select and confirm the Language menu item with
w
and
g
.
The LANGUAGE display opens.
3 Select the required language from the list with
w
and confirm
with
g
. The selection is taken over immediately. The display
switches to the higher menu level.
4 Switch to the measured value display with
m
.