YSI DIQ/S 182 XT-4-PR - Manual (Page 47)

System 182 XT-4 Installation
3 - 33 ba76027e01 02/2012
3.9 Electrical connections: General instructions
Cable glands All electric cables are fed from below via prepared openings in the
enclosure of the DIQ/S 182 XT-4-PR and the MIQ modules. Cable
glands with different clamping ranges are included with the DIQ/
S 182 XT-4-PR to provide sealing between the cable and enclosure as
well as for strain relief. Select the matching cable gland for the
respective cable diameter:
 Small, clamping range 4.5 to 10 mm. This cable gland is suitable for
all IQ S ENSOR N ET cables (including earth cable after stripping the
outer insulation, see section 3.6.4) and IQ S ENSOR N ET sensor
connection cable.
 Large, clamping range 7 to 13 mm. This cable gland is required for
cable sheaths with an outside diameter of more than 10 mm and is
screwed into the enclosure via an extension piece.
Note
If necessary, you can order other sizes of cable gland (see
chapter 12 A
CCESSORIES AND OPTIONS ).
sealing ring 20 x 15 x 1 mm
cable gland M16
blind plug
sealing ring 20 x 15 x 1 mm
extension piece M16/M20
sealing ring 24 x 19 x 2 mm
cable gland M20