YSI DIQ/S 182 XT-4-PR - Manual (Page 35)

System 182 XT-4 Installation
3 - 21 ba76027e01 02/2012
Fig. 3-13 Connect cable (example: rear terminal strip)
Note
The complete assignment of the terminal strip is shown in section 3.14.
3 Screw a cable gland (pos. 1 in Fig. 3-13) with the sealing ring
(pos. 2) into the enclosure.
4 Loosen the coupling ring (pos. 3 in Fig. 3-13).
5 Feed the cable through the cable gland into the enclosure.
6 Connect the cable ends to the terminal strip. At the same time,
look out for the designations of the terminals (red / shield /
green).
7 Tighten the coupling ring (pos. 3 in Fig. 3-13).
8 Close the enclosure.
SENSORNET 1
SACIQ SNCIQ
SNCIQ/UG
1
3
2
SENSORNET 2