YSI 5200 - Manual (Page 127)

YSI Incorporated 125 5200 Recirculating System Monitor
Section 16. Factory Default Settings
Setting Factory Default Value Your Value
Parameters—Auxiliary
Aux Input 1 Disabled
Aux Input 1 Control Close
Aux Input 1 Hold Off 15 Sec
Aux Input 1 Alarm No
Aux Input 1 Relay Disabled
Aux Input 2 Disabled
Aux Input 2 Mode Digital
Aux Input 2 Control Close
Aux Input 2 Hold Off 15 Sec
Aux Input 2 Alarm No
Aux Input 2 Alarm Low -2000
Aux Input 2 Alarm High +2000
Aux Input 2 Relay Disabled
Aux Input 2 Range 0–1V
Aux Input 2 Format 0
Aux Input 2 Min -5000
Aux Input 2 Max +5000
Aux Input 2 Suffix (blank)
Aux Input 2 Label (blank)
Parameters—Conductivity
Conductivity Enabled
Conductivity Range Auto
Conductivity Temp Comp 1.91
Conductivity Set Point 1,600 uS
Conductivity High Control 1,800 uS
Conductivity High Control Relay Disabled
Conductivity Low Control 1,400 uS
Conductivity Low Control Relay Disabled
Conductivity High Alarm 1,900 uS
Conductivity High Alarm Relay Disabled
Conductivity Low Alarm 1,300 us
Conductivity Low Alarm Relay Disabled
Conductivity Dose Up Time 30 Seconds
Conductivity Dose Up Wait 15 Minutes
Conductivity Dose Down Time 30 Seconds
Conductivity Dose Down Wait 15 Minutes