Asus NCCH-DLE - Manual (Page 94)

4 - 3 2 4 - 3 2 4 - 3 2 4 - 3 2 4 - 3 2 C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p
4.4.6 4.4.6 4.4.6 4.4.6 4.4.6 PCIPnP PCIPnP PCIPnP PCIPnP PCIPnP
This menu shows the PCIPnP configuration settings. Select an item then
press to display a pop-up menu with the configuration options.
Resources Controlled By [Auto]
IRQ Resources
PCI/VGA Pallete Snoop [Disabled]
INT Pin 1 Assignment [Auto]
INT Pin 2 Assignment [Auto]
INT Pin 3 Assignment [Auto]
INT Pin 4 Assignment [Auto]
INT Pin 5 Assignment [Auto]
INT Pin 6 Assignment [Auto]
INT Pin 7 Assignment [Auto]
INT Pin 8 Assignment [Auto]
PCIPnP Select Menu
Item Specific Help
Default is Disabled.
Select Enabled to reset
Extended System
Configuration Data
(ESCD) when you exit
Setup, if you installed
a new add-on card and
the system
reconfiguration has
caused a serious
conflict that the OS
cannot boot.
Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto] Resources Controlled By [Auto]
When set to [Auto(ESCD)], allows BIOS to automatically configure of all
boot and Plug and Play devices. When set to [Manual], you can assign the
available IRQ Resources to the PCI devices.
Configuration options: [Auto] [Manual]
When the item R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y R e s o u r c e s C o n t r o l l e d B y is set to [Auto], the item
IRQ Resources is grayed out and not user-configurable. Refer to the
section “IRQ Resources” for information on this item.
PCI/VGA Pallete Snoop [Disabled] PCI/VGA Pallete Snoop [Disabled] PCI/VGA Pallete Snoop [Disabled] PCI/VGA Pallete Snoop [Disabled] PCI/VGA Pallete Snoop [Disabled]
Some non-standard VGA cards, like graphics accelerators or MPEG video
cards, may not show colors properly. Setting this field to [Enabled] corrects
this problem. If you are using a standard VGA card, leave this field to the
default setting [Disabled]. Configuration options: [Disabled] [Enabled]
INT Pin 1~8 Assignment [Auto] INT Pin 1~8 Assignment [Auto] INT Pin 1~8 Assignment [Auto] INT Pin 1~8 Assignment [Auto] INT Pin 1~8 Assignment [Auto]
Allows you to select the appropriate interrupt to the specific devices to
avoid conflict. Configuration options: [Auto] [3] [4] [5] [7] [9] [10] [11]
[12] [14] [15]