Asus NCCH-DLE - Manual (Page 58)

3 - 2 3 - 2 3 - 2 3 - 2 3 - 2 C h a p t e r 3 : P o w e r i n g u p C h a p t e r 3 : P o w e r i n g u p C h a p t e r 3 : P o w e r i n g u p C h a p t e r 3 : P o w e r i n g u p C h a p t e r 3 : P o w e r i n g u p
3.2 Vocal POST Messages
This motherboard includes the Winbond speech controller to support a
special feature called the ASUS POST Reporter™. This feature gives you
vocal POST messages and alerts to inform you of system events and boot
status. In case of a boot failure, you will hear the specific cause of the
problem.
These POST messages are customizable using the Winbond Voice Editor
software that came with your package. You can record your own messages
to replace the default messages.
Following is a list of the default POST messages and their corresponding
actions, if any.
POST message POST message POST message POST message POST message A c t i o n A c t i o n A c t i o n A c t i o n A c t i o n
No CPU installed • Install an Intel ® Xeon™ Processor
into the CPU socket.
System failed CPU test • Check the CPU if properly installed.
• Call ASUS technical support for
assistance. See the “ASUS contact
information.”
System failed memory test • Install 184-pin unbuffered ECC or
non-ECC PC3200/2700/2100
DIMMs into the DIMM sockets.
• Check if the DIMMs on the sockets
are properly installed.
• Make sure that the DIMMs are not
defective.
• Refer to section “2.4 System
memory” for instruction on
installing a DIMM.
System failed VGA test • Install a PCI VGA card into one of
the PCI slots, or a +0.8V/1.5V AGP
card into the AGP slot.
• Make sure that your VGA/AGP card
is not defective.
System failed due to CPU • Check your CPU settings in BIOS
over-clocking and make sure you
only set to the recommended
settings.