Asus NCCH-DLE - Manual (Page 35)

A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5
2.4 System memory
2.4.1 2.4.1 2.4.1 2.4.1 2.4.1 Overview Overview Overview Overview Overview
The motherboard comes with four Double Data Rate (DDR) Dual Inline
Memory Module (DIMM) sockets.
The following figure illustrates the location of the DDR DIMM sockets.
2.4.2 2.4.2 2.4.2 2.4.2 2.4.2 Memory configurations Memory configurations Memory configurations Memory configurations Memory configurations
You may install unbuffered ECC or non-ECC 64MB, 128MB, 256MB, 512MB,
and 1GB DDR DIMMs into the DIMM sockets using the recommended
memory configurations.
Important notes Important notes Important notes Important notes Important notes
1. Installing DDR DIMMs other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations in Table 1.
2. In dual-channel configurations, install only i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l (the same
type and size) DDR DIMM pairs for each channel.
3. Always install DIMMs with the same CAS latency. For optimum
compatibility, it is recommended that you obtain memory modules
from the same vendor.
4. Make sure that the memory frequency matches the CPU FSB (Front
Side Bus). Refer to Table 2.
5. DIMMs installed into a n y t h r e e a n y t h r e e a n y t h r e e a n y t h r e e a n y t h r e e sockets will function in
single-channel mode.
6. When all four sockets are populated with 1 GB DIMMs (total 4GB),
the system may detect only about 3.6+ GB (less than 4 GB) due to
chipset limitation.
NCCH-DLE
®
DIMM_A1 DIMM_A2 DIMM_B1 DIMM_B2
80 Pins
104 Pins
NCCH-DLE 184-pin DDR DIMM sockets