Asus NCCH-DLE User Manual
Page 114
C h a p t e r 5 : D r i v e r i n s t a l l a t i o n
C h a p t e r 5 : D r i v e r i n s t a l l a t i o n
C h a p t e r 5 : D r i v e r i n s t a l l a t i o n
C h a p t e r 5 : D r i v e r i n s t a l l a t i o n
C h a p t e r 5 : D r i v e r i n s t a l l a t i o n
5 - 2
5 - 2
5 - 2
5 - 2
5 - 2
Refer to the BIOS setup for details on configuring the BIOS.
5.1.2
5.1.2
5.1.2
5.1.2
5.1.2
Installing hard disk drives
Installing hard disk drives
Installing hard disk drives
Installing hard disk drives
Installing hard disk drives
The motherboard supports Serial ATA hard disk drives for RAID set
configuration. For optimal performance, install identical drives of the same
model and capacity when creating a disk array.
To install the SATA hard disks for RAID configuration:
1.
Install the SATA hard disks into the drive bays following the
instructions in the system user guide.
2.
Connect a SATA signal cable to the signal connector at the back of
each drive and to the SATA connector on the motherboard.
3.
Connect a SATA power cable to the power connector on each drive.
5.1.3
5.1.3
5.1.3
5.1.3
5.1.3
Setting the RAID item in BIOS
Setting the RAID item in BIOS
Setting the RAID item in BIOS
Setting the RAID item in BIOS
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1.
Enter the BIOS Setup during POST.
2.
Go to the A d v a n c e d M e n u
A d v a n c e d M e n u
A d v a n c e d M e n u
A d v a n c e d M e n u
A d v a n c e d M e n u, select O n b o a r d d e v i c e
O n b o a r d d e v i c e
O n b o a r d d e v i c e
O n b o a r d d e v i c e
O n b o a r d d e v i c e, then press
3.
Select the item S A T A C o n f i g u r a t i o n
S A T A C o n f i g u r a t i o n
S A T A C o n f i g u r a t i o n
S A T A C o n f i g u r a t i o n
S A T A C o n f i g u r a t i o n, then press
the configuration options.
4.
Select R A I D
R A I D
R A I D
R A I D
R A I D from the S A T A M o d e
S A T A M o d e
S A T A M o d e
S A T A M o d e
S A T A M o d e options, then press
5.
Save your changes, then exit the BIOS Setup.