Asus NCCH-DLE - Manual (Page 131)

A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E A S U S N C C H - D L E 5 - 1 9 5 - 1 9 5 - 1 9 5 - 1 9 5 - 1 9
5.1.4.6 5.1.4.6 5.1.4.6 5.1.4.6 5.1.4.6 Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set Rebuilding a RAID set
The utility displays the condition of the RAID set during the POST. When a
RAID set is degraded, you can use the utility to rebuild it.
To rebuild a RAID array:
1. Enter the Adaptec RAID Configuration Utility following the instructions
in the section “Creating a RAID 0 (Stripe).”
2. Select A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y A r r a y C o n f i g u r a t i o n U t i l i t y from the initial menu, then
press .
Check the physical connections of the SATA hard disk drives before you
rebuild a degraded RAID set. Check the system and motherboard user
guide for additional information.
3. From the main menu, highlight Manage Arrays, then press to
display the installed RAID sets.
4. Highlight the degraded RAID set, then press to display the
array properties. The A r r a y S t a t u s
A r r a y S t a t u s A r r a y S t a t u s A r r a y S t a t u s A r r a y S t a t u s shows DEGRADED.