GE Industrial Solutions Control System Toolbox For Configuring the Trend Recorder - Manual (Page 32)

24
•
Chapter 5 Viewing Trends GEH-6408A Trend Recorder
Moving Between Events
À
To access other events
Or choose the View menu for
a list of all view commands.
w
From the toolbar, click to view the next event.
−
Or
−
w
From the toolbar, click to view the previously displayed event.
Note When you move between events, the Status bar shows which event is
currently displayed.
À To move backward or forward within an event
Or choose Rewind or
Forward from the View menu.
w
From the toolbar, click or . These buttons move back or forward
within the current event by one-third of the currently displayed width of the time
axis.
Changing The Time Axis
The range of the time axis can be changed by using the Trender Time Axis dialog
box, or see the section, Zoom In/Zoom Out.
À
To edit the time axis
w
From the Edit menu, choose Time Axis . The Trender Time Axis dialog box
displays. This dialog box varies depending on the type of trend.
Real-time and block-collected trends require a single range in seconds.
Data Historian and .dca file trends allow you to set Start and End dates and times.
(Refer to the section, Data Historian/.dca Time Axis.)
Trender Time Axis
Real-Time/Block-Collected Trends
Real-time and
block-collected trends
require a single range
in seconds for the time
axis.