Ocean Optics LIBS2000+ - Manual (Page 35)

3: Operation
Peak Analysis Mode
Option Description
Elements List Displays a list of all elements in the Elemental Library.
Scans for Selected
Line Displays the individual scan data for the selected lines in the Lines to Analyze
window.
Add Adds the selected elements from the Elements List to the Lines to Analyze list.
Add Custom Adds a blank element to the Lines to Analyze list. You must set the wavelength
after adding a custom type.
Delete Removes the selected line from the Lines to Analyze list.
Save List Saves the list of lines to an ASCII file, allowing you to load it later.
Load List Loads the saved list of lines.
Lines to Analyze Displays the list of lines for analysis including the Element Name, Wavelength,
and several other values (see table below)
Clear Calculations Clear the calculations.
Save Calculation Save the calculations to an ASCII file.
Lines to Analyze Options
Option Description
L Wave/R Wave Left and right side of the peak used to subtract background. The system draws a
line from the left and right points, then subtracts that value from the peak.
Mean Mean/average intensity of all count scans taken.
Std Dev Standard deviation of all count scans taken.
RSD Residual standard deviation of all count scans taken.
Intg Integrated values, calculated by adding the intensities from the L Wave to the R
Wave. All Intg calculations are based on this value.
161-00000-000-02-0406 25