Ocean Optics LIBS2000+ - Manual (Page 22)

2: Installing the LIBS System
Rear Panel of LIBS Imaging Module
8. Connect the 12 VDC power supply to the LIBS Sample Chamber.
9. Connect one end of the BNC cable to the LIBS Sample Chamber. Remove the cap from the
Remote Interlock (Remote Intlk) connector on the back of the laser power supply and attach the
other end of the BNC cable.
Connecting the LIBS Sample Chamber to the Laser Power Supply and Argon Gas
10. Install the fiber optic assembly in the Sample Chamber and roughly align.
11. Ensure that the switches on the rear of the laser power supply are set for external triggering.
12. If you intend to use argon gas in your set-up, connect the argon gas tank to the LIBS Sample
Chamber.
12 161-00000-000-02-0406