Ocean Optics LIBS2000+ - Manual (Page 17)

Chapter 2
Installing the LIBS System
Overview
In general, installing the LIBS2000+ involves the following steps:
► Procedure
1. Unpack and set up the LIBS2000+ components. See
Hardware Set-up
.
2. Install the OOILIBS software on the PC you intend to use with your LIBS 2000+ System, and
then restart the PC. See
Software Installation
.
3. Connect the cables to the appropriate connectors on the LIBS2000+ equipment (see
Hardware
Cabling ).
4. Test that the LIBS 2000+ System is operational (see System Start-up ).
Note
Consult the instructions provided with the LIBS Imaging Module and the laser being
used for complete installation and operation instructions for those products. General
guidelines are provided in this manual, but may not cover all the information that you
need to install and operate these components of your LIBS System.
Hardware Set-up
Set up your LIBS2000+ System in the configuration shown in the following figure. Do NOT connect any
of the cables until you have installed the OOILIBS Software.
161-00000-000-02-0406 7