PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 85
85
Diagram 4-13-3
User can enter a computer name or IP address in the pop-up "Monitor Remote Device" dialog.
Click the “OK” button to finish the setting.
Now you can find the device in the WAN, select the device from the tree view on the left side of
the window. Refer to the following diagram 4-13-4.
Diagram 4-13-4
If the Remote Control Permission switch of this Agent is not on, then you can only monitor but not
control. Refer to the following diagram 4-13-5.