PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 80
80
12. How to realize remote control of any device in different network in LAN
Precondition
The computers with PowerWalker-WinPower must setup TCP/IP protocol in the
communication protocol.
Steps for realization
Keep the communication smooth:
test with network command “PING” under command
prompt window. For example, a computer named tj2k with IP address 192.168.2.228,
you can test with command “ping 192.168.2.228”. Refer to the following Diagram 4-12-
1, which indicates that the physical link of LAN is smooth.
Diagram 4-12-1
Remote Control Permission Switch:
This is a selectable menu item. User can click the
submenu “Accept Remote Device” of the “Monitor” menu.
Refer to the following diagram 4-12-2.