PowerWalker WinPower Software V.4.3.0.1 Manual - Manual (Page 83)

83
If the Remote Control Permission Switch is on, then you can monitor and control this device. So
after you login as a super user, you can control all of the operation, Refer to the following diagram 4-
12-6.
Diagram 4-12-6
13. How to realize the Remote Control of any one of the device in Internet
Precondition
The computers with PowerWalker-WinPower must setup TCP/IP protocol in the
communication protocol.
The computer with PowerWalker-WinPower has been connected to the Internet.
Steps for realization
Keep the communication smooth: test with network command “PING” under command
prompt window. For example, a computer named ssc-test in internet, whose
corresponding IP address is 202.103.190.87, and then you can finish the test with
command “ping 202.103.190.87”. Refer to the following Diagram 4-13-1, which
indicates that the physical link of Internet is smooth.