PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 72
72
shutdown for the backup time is exhausted or the battery is in low capacitance, once
the utility power is recovered, UPS can restart automatically to the normal operating
mode. To choose “No”, when the utility power is recovered, UPS can’t restart
automatically but in the mode of being not turned on.
Click “OK” button to save what have modified. Click “Cancel” button to make the modification
invalid. Click “Default” button to make all the settings to default value.
For OFF-LINE UPS:
user can enable or disable battery mode alarm audible by this dialog, Refer to the following
diagram 4-7-2.
Diagram 4-7-2
Click “OK” button to save what have been modified. Click “Cancel” button to make the modification
invalid.
Note: If the “OK” button is invalid, it means that your access right to the current Agent is
“read only”, and you can’t carry out setup. You should log in as a super user.
8. How to realize system administrator operation and password modifying realize
System administrator operation
Click “Act as Administrator” item of “System” menu, and will pop up “Administrator” dialog. Refer to
the following diagram 4-8-1.
Diagram 4-8-1
Enter the system administrator password in the dialog, and click the “OK” button to finish the
setting. If the password is correct, you can get the administrator access right to configure the agent.
If the password is incorrect, warning message will popup. Refer to the following diagram 4-8-2.