PowerWalker WinPower Software V.4.3.0.1 Manual User Manual
Page 77
77
11. How to realize monitoring device remotely in LAN within the same network
Precondition
To realize monitoring device remotely in LAN within the same network, the communication
protocol of the computers with PowerWalker-WinPower must include TCP/IP protocol.
Steps for realization
Keep network communication smooth:
test with network command “PING” under command
prompt window. For example, a computer named xc in LAN, whose corresponding IP address is
192.168.1.221, and then you can finish the test with command “ping 192.168.1.221”. Refer to the
following Diagram 4-11-1, which indicates that the physical link of LAN is smooth.
Diagram 4-11-1
Remote Control Permission Switch:
This is a selectable menu item. User can click the
submenu “Accept Remote Device” of the “Monitor” menu. Refer to the following diagram 4-11-2.
Diagram 4-11-2