PowerWalker WinPower Software V.4.3.0.1 Manual User Manual

Page 70

Diagram 4-6-3

Configure the shutdown parameter in the dialog:

Shutdown options:

Battery backup time:

The time that the UPS's battery is able to supply power when utility power

fails.

Begin Shutdown Immediately when Battery Low:

When the check box is selected and battery

low event occurs, Agent will shut down the UPS immediately, otherwise the shutting down
time will be controlled according to battery backup time.

Shutdown System:

When this check box is selected, system will be shut down while the

appointed UPS is being turned off.

Suspend System:

When the radio box is selected, system will suspend in the disk in shutdown

sequence. The function only can be carry out on some Windows, and hibernate support must
be enabled from /Control Panel/Power Options/Hibernate.

Multi-UPS input:

When the check box is selected, system won't be shut down until all the

conditions of all selected UPS are met.

System shut down need time:

The time to be needed to shut down the system, from the

beginning of shutdown to the end.

Remote Shutdown by Agent:

When the check box is selected, system can be shut down by

other Agent.

XX min shutdown system:

Receive the specified agent's shutdown signal, delay XX minutes

and shut down system.

Run Command File before Shutdown:

Before system shutting down, Agent can execute a file,

if the parameter isn’t null, agent won’t begin to shut down the system until the execution file
has been executed.

Shutdown File Max Execution Time:

Before system shutting down, the time to be needed to

execute the shutdown file.

Shutdown Remote Agents:

Shutdown remote Agent’s Conditions:

The condition can be “UPS be shutdown” or “The time

UPS on battery exceed setting time”.

Agents be Shutdown:

When shutdown condition is touched off, Agent will send shutdown

signal to the appointed remote agents.

Shutdown Alarm Parameters:

Shutdown Alarm Interval:

The interval that agent pops up an alarm message before shutting

down.

Start Warning before Scheduled Shutdown:

If user has setup shutting down on schedule,

agent will begin to alarm user before the set time.

7. How to realize the modification of Device control parameter

For ON-LINE UPS: