Rainbow Electronics MAX7058 - Manual (Page 3)

MAX7058
315MHz/390MHz Dual-Frequency
ASK Transmitter
_______________________________________________________________________________________ 3
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
GENERAL CHARACTERISTICS
Frequency Range 300 315/390 450 MHz
ENABLE transition low-to-high, frequency
settled to within 50kHz of the desired carrier
110
Power-On Time t
ON
ENABLE transition low-to-high, frequency
settled to within 5kHz of the desired carrier
250
µs
Manchester encoded 50
Maximum Data Rate
Nonreturn to zero (NRZ) 100
kbps
Frequency Switching Time
Time from low-to-high or high-to-low
transition of FSEL to frequency settled to
within 5kHz of the desired carrier
30 µs
PHASE-LOCKED LOOP (PLL)
VCO Gain K
VCO
320 MHz/V
10kHz offset -87
f RF = 315MHz
1MHz offset -98
10kHz offset -84
PLL Phase Noise
f RF = 390MHz
1MHz offset -98
dBc/Hz
Loop Bandwidth 600 kHz
Reference Frequency Input Level 500 mV P-P
Fr eq uency- D i vi d er Rang e 21 26
CRYSTAL OSCILLATOR
Crystal Frequency f XTAL 15 MHz
Frequency Pulling by V DD 4 ppm/V
C r ystal Load C ap aci tance (Note 4) 10 pF
AC ELECTRICAL CHARACTERISTICS
( Typical Operating Circuit, 50Ω system impedance, AVDD = DVDD = PAVDD = +2.1V to +3.6V, f RF = 315MHz or 390MHz, T A =
-40°C to +125°C, unless otherwise noted. Typical values are at AVDD = DVDD = PAVDD = +2.7V, T A = +25°C, unless otherwise
noted. All min and max values are 100% tested at T A = +125°C, and guaranteed by design and characterization over temperature,
unless otherwise noted.)