Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 97)

97
9223SA-OM (V2.0)
The configuration parameters are:
•
Device Name: This field controls the top-level name of the device in the Dashboard tree.
It defaults to “Standalone Encoder”. Changes to this field take effect immediately.
•
IP Configuration: This field selects the control port IP configuration mode, as follows:
o Static IP: This option selects a static IP address, specified by the IP Address,
Subnet Mask, and Default Gateway fields.
o DHCP: This option selects control port IP address configuration by DHCP. If
this option is selected, the IP Address, Subnet Mask and Default Gateway fields
are not shown.
•
IP Address: This field is only shown if IP Configuration is set to Static IP. Enter the
desired control port IP address.
•
Subnet Mask: This field is only shown if IP Configuration is set to Static IP. Enter the
desired control port subnet mask.
•
Default Gateway: This field is only shown if IP Configuration is set to Static IP.
Enter the desired control port default gateway.
•
NTP Server: If you want the unit to be NTP-synchronized (for logging purposes), enter
the IP address of an accessible NTP server in this field. If you do not need NTP, you can
leave this field at 0.0.0.0. If your 9223-SA has access to the Internet through the control
port, you can point it to one of the public NTP servers for your region. You can find
more details on this link:
http://psp2.ntp.org/bin/view/Servers/WebHome
•
Apply/Cancel: Use these buttons to apply or cancel the changes to the control port IP
configuration. Note that if you change the IP address, DashBoard may lose contact with
the 9223-SA. The IP Address, Subnet Mask and Default Gateway entries will be checked
for consistency and will be rejected if invalid.