Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 42)

42
9223SA-OM (V2.0)
Advanced Tab – Mux Parameters
These parameters control the details of the audio/video multiplexing, and the (P)SI tables. If the
Output Protocol in the Encoder Connections Tab is set to RTMP, these parameters will not be
shown as RTMP does not use the Transport Stream container.
The following Mux Parameters are always available if the Output Protocol is not set to RTMP:
•
PMT PID, PCR PID, Video PID, Audio PID: These parameters control the Packet
Identifier (PID) values for the PMT, PCR, Video and Audio. The values can be entered
in hexadecimal (prefixed by 0x) or in decimal. Valid values are from 0x20 (32) to
0x1FFE (8190). PMT PID, Video PID and Audio PID must be distinct values. PCR PID
can either be the same as the video PID or distinct from the other values as well. The
user interface will not accept an invalid entry at any time – it will immediately revert to
the previous value. If Secondary Audio is enabled, there will be an additional entry for
the secondary audio PID. This entry will always be available for Encoder 1. For
Encoder 2, the audio PID selections will depend on whether the boxes for Include Audio
Ch1/2 are checked.
•
Program Number: Enter the desired program number for this encoder channel. Valid
program numbers go from 1 to 65535 and are always entered in decimal.
•
Transport Stream ID: Enter the desired Transport Stream ID for this encoder channel.
Values in this field can be entered both in hexadecimal (prefixed by 0x) or in decimal.
•
Generate SDT: This box is always shown but is not selectable for the HTTP Live
Streaming and RTMP protocols. If this box is checked, an SDT will be generated for this
encoder channel. Additional SDT parameters become available once this box is checked,
as depicted below.