Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 18)

18
9223SA-OM (V2.0)
Network Tab
The Network Tab allows for configuration/monitoring of the two video transport Ethernet ports
(Transport ENET 1 and Transport ENET 2).
Network Configuration Tab
The Network Configuration Tab is used to set the individual parameters for each of the Ethernet
ports.
•
The Interfaces tab is used to set the individual parameters for each of the streaming
Ethernet ports.
•
The DNS tab is used to optionally configure DNS servers.
Note: RTMP support requires that the device be capable of Domain Name Resolution (DNS
support), as many CDNs use DNS-based load-balancing.
The following parameters can be configured:
•
Alarm on Link Loss: If set to Yes, the unit will raise an alarm if this Ethernet interface
looses link. The Card State indicator in DashBoard™ and the front panel
STAT LED
will both be red. If set to No, the unit will still report loss of link in the Statistics page
but no alarm will be raised. It is recommended that the alarm for ports that are in use be
turned on; only turn it off if you do not plan to connect that port to a network.
•
IP Address: Enter the desired IP address for this Ethernet port.
•
Subnet Mask: Enter the desired subnet mask for this Ethernet port.
•
Default Gateway: Enter the desired default gateway for this Ethernet port, or 0.0.0.0 if
no gateway is available.
Configuration Tabs