Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 86)

86
9223SA-OM (V2.0)
•
Boot Location: This field indicates which image will be used in the next boot. If an
image is successfully uploaded through DashBoard, this automatically changes to point to
that image. It can also be manually changed.
•
Auto-Reboot After Update: This field controls whether or not the 9223-SA will
automatically reboot after a successful firmware upload through DashBoard. By default,
the 9223-SA will
not reboot after an update. You can upload the firmware at any time,
and reboot later during a maintenance window.
Admin Config Files Tab
As you make configuration changes to the 9223-SA, they are automatically persisted in non-
volatile storage. If the unit is rebooted or power-cycled, it will come back in the same
configuration.
In addition to automatic configuration persistency, the 9223-SA also offers the ability to save up
to 5 complete configurations, load them, and even export them. This can be used to quickly
configure it for different scenarios, or for saving configuration “checkpoints” as a complex
configuration is built. Since configurations can be exported, they can be archived outside the
unit as well.
Finally, the 9223-SA also offers 5 pre-saved configuration templates for some common
scenarios.
The layout of the Admin Config Files tab is shown below.