Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 8)

8
9223SA-OM (V2.0)
The following outputs are available:
•
Two ASI outputs
•
Two Ethernet outputs, supporting full-duplex 100 Mb/s and 1 Gb/s operation
Basically, configuring the 9223-SA includes the following steps:
Step 1: Setup the 9223-SA to connect to remote control network using DashBoard.
Step 2: Configure the encoders.
Step 3: Configure the outputs (ASI or IP).
Step 4: Make connections between inputs and outputs.
The connections between inputs and outputs can be made as part of the input or output
configuration steps. The 9223-SA supports many-to-many connections.
The overall architecture is depicted below.
Test
Generator
Inputs
Outputs
•••
••
•
ASI 1
ETH1
ETH2
Up to 4
Up to 4
Switch
ASI 2
A/V
1
Composite/SDI
Unbalanced
Audio
Sw
it
ch
Test
Generator
A/V
2
Composite/SDI
Unbalanced
Audio
Encoder
1
Mux
Encoder
2
For the remainder of this manual, the term port for a physical input/output port (such as ASI or
Ethernet), and stream for a transport stream present in the port. ASI ports support only one
stream, while Ethernet ports support multiple streams.