Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 13)

13
9223SA-OM (V2.0)
Indicators and Switches
Front Panel Indicators
•
STAT LED: indicates the overall status of the unit.
Green No active alarm
Red At least one critical alarm present
Initially, this LED will be red until operation starts. At that point, it will turn green if
there is no active alarm or stay red if there is at least one alarm.
•
PWR LED:
Green Power OK
Red No power
•
VID 1 and VID 2 LEDs
LED off no video signal detected, or input not
configured
LED flashing
– flashing once per second
– flashing 2x per second
– flashing 4x per second
Input video is SD
Input video is HD
Input video is 3G (e.g., 1080p5994)
•
AS1 1 and ASI 2 LEDs:
LED off ASI output port is disabled
LED flashing ASI output port is configured and enabled
•
ETH/CTL 1 and ETH/CTL 2 LEDs: these indicate the status of the corresponding
transport Ethernet connection.
Green LED
– LED off
– LED on
No link
Link OK
Yellow LED
– LED off
– LED Flashing
No activity (transmit and/or receive)
Port is currently transmitting and/or
receiving
•
ENC 1 and ENC 2 LEDs:
LED off Corresponding encoder channel is either
disabled, not running because of no input,
or in HLS or Direct HTTP mode.
LED flashing Corresponding encoder channel is running
and outputting through ASI, UDP or RTP.