Cobalt Digital COMPASS 9223-SA Dual-Channel 3G_HD_SD MPEG-4 Encoder Unit - Manual (Page 77)

77
9223SA-OM (V2.0)
To make the connections, simply check the Connect box in front of the input you wish to use.
You can connect any source to as many outputs as you wish. Conversely, unchecking the box
disconnects that particular source-destination pair.
Source Selection in the Output Ports
When configuring an output (ASI or IP), connections can be immediately made as well, in that
output’s configuration interface (see ASI Ports: Configuration Tab and IP Outputs:
Configuration Tab). The selection parameters are depicted below. The user-defined names for
the Encoders (and Test Packet Generators) are displayed in the user interface to facilitate
identification. To make the connection, just click on the corresponding checkbox under
Connect. Note that if an encoder channel is not available (either because it is not installed, or
because it has been configured for HTTP Live Streaming), it will not show in the list.
The Established Connections Table
As connections are established (either in the Connections tab, or as part of the source or output
configuration), they are added to the Current Connections table. Regardless of how they got