Baron Engine Guards_ENGINE GUARD Honda VTX 1300 - Manual (Page 2)

Page: 2 BA-7160-00
Engine Guard Honda VTX1300 R/S/C
is not covered by warranty! Proper cleaning procedure would be to use a product like Simple Green, LOC,
Salt-Away or similar. Mix a strong batch and apply it liberally with a soft towel or soft nylon brush to the entire
surface of the engine guard. Be sure to get the solution on all sides of the mounting brackets. Corrosives are an
invisible killer of chrome and you need to perform this procedure often.
Attachments to Engine Guard: When attaching items like highway pegs to your engine guard you should be
aware that clamps can break the chrome surface, and this will be an area where corrosion will more easily
occur. Baron recommends placing a layer of electrician or duct tape around the bar prior to installing and
tightening highway peg clamps.
No warranties or guaranties regarding personal safety are expressed or implied. Unlike the driver floorboards,
which fold up if they contact the ground while leaning excessively in a corner, these engine guards will not fold
up. In point of fact, these engine guards can, and under the proper circumstances will, lift the motorcycle off
the road causing potential loss of control if the motorcycle is leaned too aggressively in a corner.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]