Baron Air & Fuel_BIG AIR KIT PINSTRIPE, BLACK Honda Fury - Manual

Page: 1 BA-2062-00/03/06/07/13/13B
BIG AIR KIT (BAK) - Honda Fury
We recommend the use of the factory service manual and following our
instruction guidelines. When installation is complete we suggest a qualified
service center test the vehicle for proper tuning.
Revision: 5.2 - 05/24/2010
Install Time: 30 Minutes
INCLUDED IN THE KIT:
(1) Chrome or Black BAK Cover
(1) Black Intake Backing Plate
(1) Re-usable Performance Air Filter
(1) BAK Filter Raincoat
(1) Baron Power Cone
(2) 1/4-28 x 1-13/16" Hex Bolt
(2) 1/4" Lock Washers
(4) M5-.80 x 16mm Button Head Allen Head Bolt
(1) M6-1.0 x 100mm Flathead Bolt
(1) Thick O-Ring
(1) Short piece of 5/16" O.D. Fuel Hose
(1) 3 1/4" L x 1/2" O.D. Spacer Tube
TOOLS REQUIRED:
4mm & 5mm Allen Wrenches
Medium Tip Phillips Screwdriver
10mm Socket and 4" Extension
Socket Driver
INSTRUCTIONS:
RECOMMEND: Use Blue Loctite® on all threaded hardware.
NOTES: Before you begin, be sure to check your BAK kit contents against the hardware list above. To help
ensure your BAK cover does not get scratched or damaged during installation, we suggest you slice the plastic
covering around the base of the packaging, so you can leave the plastic in place during the installation.
1. Remove the stock air cleaner from the right side of your bike by unscrewing the (4) 5mm allen screws around
the outside edge of the chrome cover.
2. Remove the chrome cover and then remove the air filter.
3. Remove the 10mm hex head bolt located inside the bottom portion of the black air box using your extension
and 10mm socket.
4. Remove the (4) 5mm phillips screws from the air box that surround the throttle body. This will allow the air
box to be removed from the bike and placed aside. You will not reinstall this part.
5. Slide the thick O-ring (Supplied) over the crankcase vent return located at the 10 o'clock position on the
throttle body and be sure the o-ring is pushed back as far as it can go.
7. For the next step you will need the following items: Backing Plate, Short piece of 5/16" and Fuel hose - Take
the backing plate and insert the 5/16" fuel line into the counter-bored hole on the rear (side without the groove)
in the 6 o'clock position.
8. Put Blue Loctite® in the four threaded holes at the corners of the throttle body.
9. Place the backing plate against the throttle body being sure the plastic fittings at 10 and 6 o'clock side into
and through the o-ring and fuel hose, push the plate against the throttle body, insert the (4) M5-.80 x 16MM
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]