Grain Systems Unload Augers PNEG-1421 - Manual (Page 41)

5. Operation
PNEG-1421 Direct Gear Drive Bin Sweep Auger (with Roller Wells) 41
5. When grain flow stops from the center well, close the center well gate. Insert the safety snap pin
through the control lever and both the intermediate and center well control rods as Figure 5E .
The remaining grain should look similar to Figure 5D .
Figure 5D
Figure 5E
6. Gradually open gates using the middle pivot slot until the desired flow of grain is reached. You
should not open the gates more than 2" to 4". If gates need to be opened further, use the last
slot for more leverage.
(See Figure 5C on Page 40.) The remaining grain should look similar
to Figure 5F .
Figure 5F