Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 73)

9. Maintenance
PNEG-720-G2 12" and 16" Series II Sweep 73
O. Type of Lubrication
The type of lubrication required, for each component, is listed in the following Chart .
NOTE: The pour point of the lubricant selected should be at least 10°F lower than the expected minimum
ambient starting temperature. Extreme pressure (EP) lubricants are not recommended for average
operating conditions.
Lubrication - Bearings, Casters and Misc. Equipment
Type of Lubricant
Equipment Lubrication Specification
Tractor Drive Pillow Blocks Shell Oil Company Alvania #2 (or equivalent)
End Flange Bearing Shell Oil Company Alvania #2 (or equivalent)
Nylon Flight Bearings None Required None Required
Head End Casters Shell Oil Company Alvania #2 (or equivalent)
Jack Casters Shell Oil Company Alvania #2 (or equivalent)
Jacks Shell Oil Company Alvania #2 (or equivalent)
Too much oil will cause overheating and too little will result in gear failure.
Check oil level regularly.
NOTICE
Extreme pressure (EP) lubricants are not recommended for average operating
conditions. Failure to observe these precautions could result in damage to or
destruction of the equipment.
NOTICE
Under Extreme operating conditions, such as rapid rise and fall of temperatures,
dust, dirt, chemical particles, chemical fumes or oil sump temperature above
200°F, the oil should be changed every one to three months, depending on
severity of conditions.
NOTICE
CAUTION
If the unit is used in the food or drug industry (including animal food) consult the
petroleum supplier for recommendations on lubricants which meet the
specifications of the FDA, USDA and/or other authoritative bodies having
jurisdiction. Standard lubricants are not suitable for these applications or
these industries.
WARNING
Oil, housings and other components can reach high temperatures during
operation and can cause severe burns. Use extreme care when removing
lubrication plugs and vents while servicing the unit.