Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 12)

2. Safety Decals
12 PNEG-720-G2 12" and 16" Series II Sweep
Figure 2A
Decal “A”
Location:
Exterior of chain guard
Size: 2" x 4-1/2"
Part No.: DC-1386
SHEAR POINT
Moving parts can
crush and cut. Keep
hands clear of
sprocket and chain.
DC-1386
Decal “B”
Location:
Two (2) per section on
front of top flange
Size: 4-5/16" x 5-7/16"
Part No.: DC-1416
ROTATING AUGER!
• DISCONNECT AND LOCKOUT POWER BEFORE
SERVICING, ADJUSTING OR CLEANING.
• KEEP HANDS, FEET, HAIR AND LOOSE
CLOTHING AWAY FROM ROTATING AUGER AND
MOVING PARTS AT ALL TIMES.
• NEVER REMOVE OR MODIFY GUARDS OR
SHIELDS.
FAILURE TO HEED WILL RESULT IN
SERIOUS INJURY OR DEATH!
DC-1416
DANGER DANGER
Decal “C”
Location:
Centered on motor mount
Size: 5-1/2" x 7-3/8"
Part No.: DC-1379
Danger Do not put fingers in Auger
1. READ AND UNDERSTAND THE OPERATOR’S MANUAL
AND ALL SAFETY INSTRUCTIONS.
2. DO NOT OPERATE WHILE UNDER THE INFLUENCE OF
DRUGS OR ALCOHOL.
3. DO NOT OPERATE UNLESS ALL SAFETY EQUIPMENT,
SWITCHES, GUARDS AND SHIELDS ARE SECURELY IN
PLACE AND OPERATIONAL.
4. ALLOW ONLY TRAINED AUTHORIZED PERSONNEL IN
THE OPERATING AREA.
5. ANY ELECTRICAL WIRING OR SERVICE WORK MUST
BE PERFORMED BY A QUALIFIED ELECTRICIAN. IT MUST
MEET ALL STATE AND LOCAL ELECTRICAL CODES.
6. DO NOT ALLOW CHILDREN IN THE AREA OF OPERATION.
7. KEEP HANDS, FEET AND CLOTHING AWAY FROM
MOVING PARTS.
8. DISCONNECT AND LOCKOUT POWER BEFORE
MAKING ANY ADJUSTMENTS OR PERFORMING ANY
SERVICE WORK.
9. DISCONNECT POWER PRIOR TO RESETTING ANY
MOTOR OVERLOAD.
10. MAKE CERTAIN ALL ELECTRIC MOTORS ARE GROUNDED.
11. REPLACE ALL WORN OR DAMAGED LABELS IMMEDIATELY.
DC-1379
Decal “D”
Location:
Corner of motor mount
Size: 2-7/8" x 5"
Part No.: DC-1224
DC-1224
DANGER DANGER