Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 43)

5. Assembly
PNEG-720-G2 12" and 16" Series II Sweep 43
D. Slide the bushing and small sheave onto the motor shaft with a key. (See Figure 5Y.)
Figure 5Y
E. Align the sheaves with a straight edge to assure proper alignment and tighten the screws on the
bushings. (See Figure 5Y.)
F. Carefully install the belts onto the large and small sheaves. (See Figure 5Z on Page 44.)
NOTE: Adjust the hex nuts on the motor mount adjustment rod to attain correct belt tension while making
sure the motor mount is level on both rods. The motor mount must be parallel to the auger screw
to allow for proper sheave alignment.