Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 33)

5. Assembly
PNEG-720-G2 12" and 16" Series II Sweep 33
Key Alignment
A. Place key in keyway on drive shaft.
B. Make sure key is flat (parallel to drive shaft) in keyway as in Figure 5N_1 and Figure 5N_2 . NOT
like Figure 5N_3 .
Figure 5N
CAUTION
All keys should be parallel to the drive shaft. If the key is not straight (parallel) the
gear box quill sleeve will crack.
THIS TYPE OF DAMAGE IS NOT COVERED BY WARRANTY.