Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-720-G2 - Manual (Page 64)

64 PNEG-720-G2 12" and 16" Series II Sweep
7. Operation
Operating the Sweep Auger
NOTE: The auger capacity can fluctuate greatly under varying conditions. Moisture content, different
commodities, amount of foreign matter and speeds all play a part in the performance of the auger.
Twenty-five percent (25%) moisture may cut capacity by as much as 40% under some conditions.
A. Make certain there are at least two (2) people in the work area to monitor operations at all times.
B. Start the bin unloading equipment before starting the bin sweep auger.
C. Shut down the auger as soon as the bin is empty.
D. Consideration should be given to the proper size auger for any intermittent type operations. When
augers are stopped and restarted under full load, it may result in damage to the auger. Using a larger
diameter auger and reducing its load level will be far better than subjecting a smaller diameter auger
to big loads. If an auger is kept from absolute filling, it will make start-up easier and will convey
more efficiently.
NOTICE
Gear Reducer is shipped without oil. Add the proper amount of the
recommended lubricant before operating. Failure to observe these precautions
could result in damage to or destruction of, the equipment.
DANGER
Danger! Keep out of the bin while the bin sweep auger is in operation. The
rapidly moving sweep auger can cause SERIOUS INJURY or DEATH.
CAUTION
Be alert for any unusual vibrations, noises and the loosening of any fasteners. If
anything unusual is detected, immediately shut down the auger, disconnect and
lock out the power source before servicing.
NEVER enter the bin while the bin sweep is in operation.
NEVER attempt to control the operation of the bin sweep by depressing the
operating controls with shovels, brooms or any other objects.
DO NOT attempt to restrain movement of the bin sweep with ropes, bars or
other devices.
NEVER allow an operator to attempt to manually restrain the bin sweep.
DANGER