Grain Systems PNEG-573 - Manual (Page 20)

20
SERIES 2000 DRYER CONTROL PANEL SERIES 2000 DRYER CONTROL PANEL SERIES 2000 DRYER CONTROL PANEL SERIES 2000 DRYER CONTROL PANEL SERIES 2000 DRYER CONTROL PANEL
Figure 5: The Competitor Series 2000 Control System Figure 5: The Competitor Series 2000 Control System Figure 5: The Competitor Series 2000 Control System Figure 5: The Competitor Series 2000 Control System Figure 5: The Competitor Series 2000 Control System
the dryer is restarted the timers will
continue timing down. The timers
will return to their initial settings by
pressing and holding the STOP
button for 5 seconds. automatically entered.
3. Keep pressing the PROGRAM
(DELAYS) button until the car-
rot disappears or press the MODE
SELECT button once to exit.
SETTING THE LOAD AND SETTING THE LOAD AND SETTING THE LOAD AND SETTING THE LOAD AND SETTING THE LOAD AND
UNLOAD DELAYS UNLOAD DELAYS UNLOAD DELAYS UNLOAD DELAYS UNLOAD DELAYS
1. Press the PROGRAM (TEM-
PERATURES) button until the
carrot is under the temperature
setting to be changed.
2. Use the UPand DOWN arrow
keys to change the present tem-
perature to the new one. The
new time is automatically entered.
3. Keep pressing the PROGRAM
(TEMPERATURES) button until
the carrot disappears or press the
MODE SELECT button once to exit.
CHECKING THE HOUR CHECKING THE HOUR CHECKING THE HOUR CHECKING THE HOUR CHECKING THE HOUR
METER METER METER METER METER
MONITORING GRAIN MONITORING GRAIN MONITORING GRAIN MONITORING GRAIN MONITORING GRAIN
TEMPERATURES, PLENUM TEMPERATURES, PLENUM TEMPERATURES, PLENUM TEMPERATURES, PLENUM TEMPERATURES, PLENUM
TEMPERATURE OR TIMERS TEMPERATURE OR TIMERS TEMPERATURE OR TIMERS TEMPERATURE OR TIMERS TEMPERATURE OR TIMERS
DRYER SAFETY CIRCUIT DRYER SAFETY CIRCUIT DRYER SAFETY CIRCUIT DRYER SAFETY CIRCUIT DRYER SAFETY CIRCUIT
The LOAD DELAY is used to delay the
starting of the load auger
load auger load auger load auger load auger when the
dryer is unloading to prevent the load load load load load
auger auger auger auger auger from starting and stopping too
often. The UNLOAD DELAY is used to
control the amount of time the unload
unload unload unload unload
auger auger auger auger auger runs after the metering rolls metering rolls metering rolls metering rolls metering rolls
stop to allow for auger cleanout.
1. Press the PROGRAM (DELAYS)
button until the carrot is under the
time delay to be changed.
2. Use the UP and DOWN arrow
keys to change the present time
to the new one. The new time is
SETTING THE MOISTURE SETTING THE MOISTURE SETTING THE MOISTURE SETTING THE MOISTURE SETTING THE MOISTURE
CONTROL AND PLENUM CONTROL AND PLENUM CONTROL AND PLENUM CONTROL AND PLENUM CONTROL AND PLENUM
SET POINT SET POINT SET POINT SET POINT SET POINT
Press the UP arrow key and the total
hours on the machine are displayed.
Use the mode select to decide which
of the modes you want to view.
The Competitor Series 2000 Con- Competitor Series 2000 Con- Competitor Series 2000 Con- Competitor Series 2000 Con- Competitor Series 2000 Con-
trol System trol System trol System trol System trol System continuously checks all
safety circuits on the dryer, and will
automatically shut the dryer down
should a problem occur. The cause
of the dryer shutdown will be shown
on the LCD display. To restart the
dryer after a safety shutdown, first
correct the reason for the shutdown,
and then press the DRYER POWER
STOP button to reset the circuit.
Press the START button.