VEGA WHA-GW-WIRELESSHART GATEWAY - Manual (Page 75)

WHA-GW-*
Operation
22
1981
2011
-0
7
75
6.3.1 Reset
Figure 6.9Additional Functions > Reset
Additional Functions > Reset
6.3.2 Self Test
After pressing the Perform Self-Test button in the Additional Functions > Self Test
menu the device carries out a self test.
The results of the self test can be seen in the Diagnosis menu (see chapter 6.2).
Parameter Description
Device Reset Press this button to restart the Gateway software application without
any impact on the established network (which is not reformed).
This function does not set the parameters of the WHA-GW back to
their default values. It only restarts the Gateway software.
Rebuild
Instrument
List Press this button to generate the Instrument List (see chapter 5.4.2,
see chapter 6.3.5) from scratch.
The existing Instrument List is overwritten. Note that the Modbus
addresses of the devices in the network will be changed by resetting
the Instrument List!
It is recommended to create a backup of the existing Instrument List
first (see chapter 6.3.5).
Reform
Network Press this button to restart and reestablish the network. For example,
this function is needed to activate a new Network ID (see chapter
5.4.1). Depending on the size of the network, this process may take
several minutes.
This function does not set the parameters of the WHA-GW back to
their default values. It only restarts the network.