beautypg.com

Wha-gw, Installation, Connecting to ethernet network – VEGA WHA-GW-WIRELESSHART GATEWAY User Manual

Page 26

background image

22

1981

2011

-0

7

26

WHA-GW-*

Installation

Connecting to Ethernet Network

1. Unscrew the 4 screws of the housing cover (see Figure 3.6 on page 23).

2. Remove the housing cover.

3. Route the Ethernet cable through the cable gland in the middle of the Gateway housing.

The permissible cable diameter lies between 6 ... 10 mm.

4. Connect the Ethernet cable to the terminal block labelled "Ethernet" (see Figure 3.9 on

page 26) according to the following figure/tables.

5. Screw the housing cover to the housing again.

6. Tighten the cable gland with appropriate torque (see table "Installation torque cable

glands" on page 32).

The Gateway is now connected to the Ethernet network. The yellow Ethernet
communication status LED starts flashing when a correct HART or Modbus protocol
message is received (see chapter 6.1).

Figure 3.9Ethernet interface

Figure 3.10Gateway Ethernet wiring

1 Straight through connection with an T568A plug

or

Crossover connection with a T568B plug

2 Crossover connection with an T568A plug

or

Straight Through connection with a T568B plug