VEGA WHA-GW-WIRELESSHART GATEWAY - Manual (Page 42)

WHA-GW-*
Commissioning
22
1981
2011
-0
7
42
Parameter window of Ethernet communication DTM
6. Set the parameters according to your preferences. In most cases, the default values
should be fine.
7. In some cases you might have to edit the Additional Functions > Set DTM addresses
menu. Please read the following instructions for further information.
8. Click OK to save the changes and to close the parameter window.
Editing Additional Functions > Set DTM addresses of the HART IP
Communication DTM
The Additional Functions > Set DTM addresses menu contains settings which are
important for establishing a connection between the communication DTM and the
Gateway. The IP address, bus address and UDP port set in this menu must match the
corresponding parameters set in the gateway. When using a new Gateway, there is no
need to change the following parameters, because the default settings of the gateway
match the default settings of the HART IP Communication DTM.
1. Right-click on the entry HART IP Communication.
Ethernet communication DTM in PACTware project
A context menu is displayed.
2. Choose Additional Functions > Set DTM addresses.
The Set DTM addresses window is displayed.
HART IP Communication > Additional Functions > Set DTM addresses
3. Change the parameters as required (see following table).
4. Press Update changed data to apply the new settings.
5. Disconnect and reconnect the communication and the Gateway DTM to activate the
new settings.