VEGA WHA-GW-WIRELESSHART GATEWAY - Manual (Page 67)

WHA-GW-*
Operation
22
1981
2011
-0
7
67
Figure 6.4DIP switches
Function of button [A + B] (security mode enabled)
> 3 seconds Network Manager reset: When pressed while the Security Mode
is enabled (see Figure 6.4 on page 67), the buttons set the join
key, network ID, radio power and access mode back to factory
settings.
After 3 seconds, all LEDs light up to confirm the reset.
1 Switches 1 - 4: Polling address
2 Switches 5 - 6: Baud rate
3 Switch 7: RS-485 termination
4 Switch 8: Security mode
Time pressed Function
Note!
When using the DIP switches 1 ... 4 for setting the Gateway's polling address, only
addresses ranging from 0 ... 15 can be set. Alternatively you may set the polling address
using the configuration software (see chapter 5.5.3, see chapter 5.5.4). Via software it is
possible to set addresses ranging from 0 ... 63 (HART) or 0 ... 247 (Modbus).
DIP switches 1 ... 4
SW1 SW2 SW3 SW4 Polling address
OFF OFF OFF OFF 0
ON OFF OFF OFF 1
OFF ON OFF OFF 2
ON ON OFF OFF 3
OFF OFF ON OFF 4
ON OFF ON OFF 5
OFF ON ON OFF 6
ON ON ON OFF 7
OFF OFF OFF ON 8
ON OFF OFF ON 9