VEGA WHA-GW-WIRELESSHART GATEWAY - Manual (Page 33)

WHA-GW-*
Commissioning
22
1981
2011
-0
7
33
4 Commissioning
4.1 Important Steps to Getting Started
There are different possibilities how to connect to the gateway and how to configure the
gateway. The following overview tells you which steps to take. But first, please answer the
following question.
Are you going to configure the gateway via DTM software or via the browser-based web
interface?
• DTM software: Please follow the instructions given in "Configuring via DTM software"
below.
• Web interface: Please follow the instructions given in "Configuring via browser-based
web interface" below.
Configuring via DTM software
1. Download and install the following software components, if not already installed: Mi-
crosoft
®
.NET Framework, PACTware
®
Framework, DTM Collection, HART CommDTM
(see chapter 4.2).
2. Connect to the gateway via the RS-485 interface (see chapter 4.4) or the Ethernet
interface (see chapter 4.5).
3. Create a new PACTware project (see chapter 4.6).
4. Configure the gateway via DTM (see chapter 5.1).
Configuring via browser-based web interface
1. Download and install a web browser, if not already installed (Microsoft
®
Internet Explorer
v7 or higher, Mozilla Firefox v3 or higher).
2. Connect to the gateway via the Ethernet interface (see chapter 4.5).
3. Configure the gateway via your web browser (see chapter 5.1).
4.2 DTM Software
4.2.1 Downloading the required software
Required software:
• Microsoft
®
.NET Framework
• PACTware
TM
Framework
• WirelessHART DTM
The DTM collection including WirelessHART device DTMs and Ethernet communication
DTM.
• HART CommDTM
The HART CommDTM has to be installed separately if serial HART communication via
the Gateway's RS-485 interface is required. The HART CommDTM supports both
FSK (i.e. HART modem) and RS-485 interfaces.