VEGA VEGASON 51V…53V - Manual (Page 43)

VEGASON 51 V … 53 V 43
Set-up - Adjustment with PC on VEGAMET
• Plug the two small pin plugs of
VEGACONNECT 2 into the CONNECT-
socket of the signal conditioning instru-
ment.
• Now switch on the voltage supply of the
signal conditioning instrument.
After approx. 1…2 minutes (selfcheck) the
meas. system is generally ready for opera-
tion and indicates measured values.
• Now start the adjustment software VVO on
your PC.
• Choose in the entrance screen with the
arrow keys or the mouse the item " Plan-
ning" and click to "OK".
In the next window you are asked for the
user identification.
• Enter under the name "VEGA".
• Also enter under the password
"VEGA".
The adjustment program, just called VVO,
gets in contact with connected coordination/
sensor...... and indicates after a few seconds
if and with which coordination/sensor a con-
nection exists.
The preadjusted identification can be modi-
fied later in the menu "User access".
Note:
If you do not get a sensor connection, please
check:
- is the sensor fed with power supply (min.
20 V)?
- do you use an older VEGACONNECT
instead of the new VEGACONNECT 2 ?
If VVO (adjustment software) gets in contact
with the signal conditioning instrument for the
first time, you are asked if the data should be
transferred from the signal conditioning in-
strument to the PC.
• Click to " Yes"
In the following menu window " DISBUS-group
choice" you can give a name to the database
or keep the suggested file name.