Veris Industries VWG-40 Install - Manual (Page 6)

6
R e m o v i n g a n d R e p l a c i n g t h e C o v e r
You must remove the VWG cover to connect the battery (new unit) or to replace the battery. The cover snaps onto the
base with four plastic tabs (two on each end).
To remove the cover, press in the four tabs on both ends of the unit, and lift the cover off. If accessory modules are
plugged into the VWG, you may need to slide them away from the unit to get to the cover tabs. To replace the cover,
orient it so the cutout area for communication ports is correct, then push inwards to snap in place.
Installation Minimum Spacing Distance Requirements
Make sure minimum spacing distance requirements is available to freely rotate wireless antenna in all possible
orientations.