M&C TechGroup MP47-Z-BPR150 Operator's manual - Manual (Page 10)

10
Gas sampling and gas conditioning technology 6-1.1.7-ME
• Check the goods for any damage incurred during transport and, if necessary, inform your trans-
port insurer of any damage.
N O T E !
The equipment should be stored in a protected, frost-free room!
11 INSTRUCTIONS FOR INSTALLATION
During installation, the safety instructions as well as those for accident prevention must be heeded,
also with regard to the later operation. Further, the safety instructions under chapter 3 must be kept.
N O T E !
Please comply with the respective safety instructions regarding
the samples to be delivered.
In order to avoid any heat accumulation, the pump should be
installed away from heat sources and should also be freely venti-
lated.
When mounting the pump outside, it must be installed in a protec-
tive housing, frost-protected in winter and sufficiently aerated in
summer. Direct solar radiation must be avoided.
The pumps MP47-Z-BPR150 are executed according to protection type IP20 and, therefore, do not
supply any protection against contact and foreign bodies.
W A R N I N G
It is very important to provide a protection for persons against
contact of live parts (eg. electrical connections) or moving parts.
It must also be taken care to protect the pump against penetration
of foreign bodies.
N O T E !
Pumps have mechanical moving parts that can induce vibrations.
To prevent damages at the pump or at peripheral components /
facilities as well as minimizing noise development an appropriate
vibration decoupling is necessary. For this M&C can deliver e.g.
anti-vibration pads.
This explicit is also valid for the connection of the sample lines at
the pump head.