M&C TechGroup MV3_2-H Series Data sheet - Manual

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany
[email protected] • www.mc-techgroup.com • Fon +49 2102 935-0 • Fax +49 2102 935-111
11.3
Embracing Challenge
ƒ ƒ
Electrically heated up to max. 180 °C
ƒ ƒ
Integrated thermostat
ƒ ƒ
Status contact output
ƒ ƒ
Sure connection technique
ƒ ƒ
No cold bridges
ƒ ƒ
Easy to maintain
ƒ ƒ
Option ball valve with position identifi-
cation
Special Features
Electrically heated valves
series V3/2-H, MV3/2-H
Version V3/2-H /PE, 3/2-way ball valve, electrically heated up
to 180 °C, Version MV3/2-H, 3/2-way solenoid valve, electrically
heated up to 180 °C
V3/2-H
Application
In analysis technique, often temperatures
must be kept above the sample gas dew
point. Therefore, it is absolutely necessary to
avoid cold bridges. In order to ensure this,
the temperature regulated M&C three-way
valves V3/2-H and MV3/2 H are used for the
cut-off or switching-over of sample gases and
test gases up to an operating temperature of
180 °C.
Description
The M&C electrically heated valves are fixed
on a mounting plate, decoupled from heat
and covered with an insulated enclosure. The
heater consists of a heating element with
high capacity. The temperature is adjustable
on the integrated thermostat up to 180 °C
with high temperature limiter and low tem-
perature alarm.
The heat insulated enclosure with a bushing
for the dial thermometer is equipped with
quick acting bentlever closures. The connec-
tion box with integrated thermostat is installed
outside the enclosure on the mounting plate.
Version V3/2-H/PE has got an additional con-
necting box for the contact output of the
position identification. The power supply for
the solenoid valves version MV3/2-H is 24V
DC and the additional connecting box is
installed on the mounting plate. In order
to prevent cold bridges, the connecting fit-
tings are heated by means of thermal con-
ducting jaws. The electrically heated sample
lines type 3/4/5-N/M/H – see data sheet
3.1 – are fixed with mounting brackets.
Technical specifications and illustrations are without
obligation, subject to modifications. 03.96/11.06