M&C TechGroup SP30-H1.1-V_EX2 Data sheet - Manual

M&C TechGroup Germany GmbH • Rehhecke 79 • 40885 Ratingen • Germany
[email protected] • www.mc-techgroup.com • Fon +49 2102 935-0 • Fax +49 2102 935-111
2.16
Embracing Challenge
ƒ ƒ
Approval according to ATEX for sam-
pling from Ex-zone 2
ƒ ƒ
Approval according to ATEX for mount-
ing in Ex-zone 2
ƒ ƒ
Completely heated sample tube
ƒ ƒ
Electronic temperature controller
ƒ ƒ
Different lengths
ƒ ƒ
Unheated pre-filters or extensions pos-
sible
ƒ ƒ
Simultaneously heated pre-filter pos-
sible
ƒ ƒ
Easy mounting
ƒ ƒ
Two temperature sensor versions
Special Features
Electrically heated sample probe
tube series SP®
Version SP30-H1.1/EX2, SP30-H2/EX2 and SP30-H1.1-V/EX2
for gas sample probe SP3200 and SP3200V
for sampling from and mounting in ex-zone 2
SP30-H1.1/EX2
Application
The electrically heated M&C sample probe
tube SP30-H../EX2 is used in extractive sam-
pling systems to avoid cooling and conden-
sation of the sample in the insitu tube from
the sample point to the heated sample probe
SP3200-H. It can be used for sampling from
Ex-zone 2 and mounting in Ex-zone 2.
To avoid a premature demage by cooling
and condenstaion in dust loaded proc-
esses, we recommend a heated tube type
SP30-H1.1-V/EX2, including an insitu pre-filter
V20-2/30, heated up with the tube.
Description
The electrically heated M&C sample tube
SP30-H../EX2 is available in 0,6 m and 1,0 m,
length.
With a mounting flange with 4 welded screws
the heated sample tube SP30-H../EX2 can
be easily fixed both to the flange at the
sample point and the probe head SP3200-H.
The heated sample tubes SP30-H1.1/EX2 and
SP30-H2/EX2 is equipped with a G3/4»i thread
connector at the tube end. This enables fixing
a standard non heated sample tube or pre-
filter to the heated insitu tube.
The electrical cartridge heater is located inside
a double tube system, completely separated
from the process. At the version SP30-H1.1-V/
EX2 the included large pre-filter V20-2/30 is
heated up with the sample tube.
The temperature of the heated tube has to
be adjusted in relation to the temperature
class. The tube versions SP30-H1.1/EX2 and
SP30-H2/EX2 have an internal diameter of
22 mm. The internal diameter of the version
SP30-H1.1-V/EX2 is reduced to 6 mm to opti-
mise the tube dead volume.
For temperature control of the heated sample
tube the electronic controller HEX5-0.2.08 is
used. It is applicable for separate mounting
in Ex-zone 2. The controller depending on
the desired temperature class is programmed
correspondingly ex works.
Technical specifications and illustrations are without
obligation, subject to modifications. 11.09