M&C TechGroup FM-200K-H_FA Operator's manual - Manual (Page 11)

11
Gas sampling and gas conditioning technology 5-6.5.1-ME
16 ELECTRICAL CONNECTION
W A R N I N G !
When connecting the equipment, please ensure that the supply
voltage is identical with the information provided on the model type
plate.
N O T E !
Attention must be paid to the requirements of IEC 364 (DIN VDE
0100) when setting high-power electrical units with nominal
voltages of up to 1000 V, together with the associated standards
and stipulations.
A main switch and matching fuse must be provided externally!
The main circuit must be equipped with a fuse corresponding to
the nominal current (over current protection), for electrical details
see technical data.

Remove the lid of the electrical connection box. The electrical connection layout is located in
the lid.

Insert the mains cable (min. 3 x 1.5 mm²) through the cable gland and connect to the
appropriate terminals.

Insert the signal cable through the cable gland and connect to the appropriate terminals.

Screw lid back on.