AASTRA 4425 IP Vision for MD Evolution User Guide - Manual (Page 6)

Installing Your Extension
MD Evolution – Dialog 4425 IP Vision 6
Installing Your Extension
Your Dialog 4425 IP Vision is usually installed by your system
administrator.
However, this section provides you with all of the instructions for
installing your extension yourself and for maintaining it.
Installing Your Extension’s Telephone
Cords
Your extension is connected to your company’s local area network
(LAN) through a network cable that connects into the RJ45 female
jack labelled LAN, located on the underside of your extension.
It is usually powered with a 230-volt power cord and a 24-volt
adapter connected to the jack also located on the underside of
your extension.
The handset cord is connected to the RJ12 female connector
labelled HANDSET located, once again, on the underside of your
extension. This may be installed so that it comes out of either the
left or right side of your extension. In the first case, the handset
cord should be inserted in the slot made for this purpose, as
illustrated in the diagrams below.
Mains Mains